Por la presente, TELTONIKA NETWORKS declara que este RUT950 cumple con los requisitos esenciales y otras exigencias relevantes de la Directiva 2014/53/EU Factory reset. If the reset button is pressed for at least 5 seconds (by default), the device will perform a factory reset and reboot. In case server hostname resolve fails, this field indicates the amount of time (in seconds) to retry the resolve. Specify infinite to retry indefinitely. Turn aggressive mode on or off for outgoing connections. Aggressive mode performs fewer exchanges (a total of 4 messages) than Main mode (a total of 6 messages) by storing most data into the first exchange. In aggressive mode, the information is exchanged before there is a secure channel, making it less secure but faster than main mode. IKEv2 - updated version with increased and improved capabilities, such as integrated NAT support, supported multihosting, deprecated exchange modes (does not use main or aggressive mode; only 4 messages required to establish a connection).

TCP/UDP port number used for the connection. Make sure it matches the port number specified on the server side. Fixed preserving the contents of /etc/luci-uploads/ after FW upgrade with the 'Keep all settings' option In the General section of Peer instance you can configure basic information about the endpoint to allow communications. Enables NTPD server to make the router act as an NTP server so that it can provide time synchronization services for other network devices.A TELTONIKA NETWORKS ezzennel kijelenti, hogy a RUT950 típusú berendezés teljesíti az alapvető követelményeket és más 2014/53/EU irányelvben meghatározott vonatkozó rendelkezéseket

The DHCP protocol is used to set up an interface which obtains its configuration parameters automatically via a DHCP lease. Added netifd, odhcp6c IPv6 routing loop on point-to-point links patches to fix CVE-2021-22161 vulnerability The received data limit before sending an SMS warning. After reaching using the the amount of data specified in this field, the router will send an SMS warning message to the specified phone number. warning) - anything that can potentially cause application oddities, but for which the system is automatically recovering from (e.g., retrying an operation, missing secondary data, etc.) Before starting operating the device, please review recommendations and precautions to minimize the possibility of accidents. Safety precautions presented are supplementary and subject to the local safety regulations. When various operations are executed on the device, the user must fully follow the safety instructions and recommendations provided with the device.QoS / Smart Queue Management (SQM): Traffic priority queuing by source/destination, service, protocol or port, WMM, 802.11eDDNS: Supported >25 service providers, others can be configured manually Do not attempt to disassemble your device (exemptions for devices that require disassembly for SIM insertion) or its accessories: it does not contain any user-serviceable parts. For safety reasons, the equipment should be opened only by qualified personnel. The connection settings section is used to configure the main parameters of an IPsec connection. Refer to the figure and table below for information on the configuration fields located in the connection settings section. The proposal settings section is used to configure IKE (Internet Key Exchange) phase 1 & 2 settings. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

Choose this option if you want to select certificate files from device. Certificate files can be generated in Certificates section. Maximum time (in seconds) the button can be held to perform an action, after which no action will be performed. External antennas used with RUT950 must be installed to provide a distance of at least 20 cm from any people and must not be co-located or operated in conjunction with any other antenna or transmitter.The method that your carrier uses to authenticate new connections on its network. If you select PAP, CHAP or The Access Concentrator to connect to. ISPs used Access Concentrators to route their PPPoE connections. Usually, the settings are received automatically, however in some cases it is required to specify the name for an Access Concentrator. Leave empty to detect Access Concentrators automatically.